Apexis IP Wireless / Wired CameraREMOTE PAN/TILT ROTATE Instalační příručka stáhnout pdf (Strana 3)

Step 1: Hardware Installation

1. Install the antenna.

2. Plug in the right power supply.

3. Connect your camera to the wireless router (Modem or Switcher) with net cable.

Screw the antenna to the back of the camera; Make sure it is attached securely.Connect your

camera to the router, modem or switcher with net cable. Plug in the power. After a while, the

yellow network light at the rear of the camera will blink and the camera will pan and tilt

automatically. The green power light will keep on.( If off, said the search network fails, pls

check the network cable is correctly used)

1 2 3 4 5 6 7 8 ... 12 13

Žádné komentáře

Apexis IP Wireless / Wired CameraREMOTE PAN/TILT ROTATE Instalační příručka Strana 3